MONIMET Co2 Sensor GMM 04.14
MONIMET CO2 Monitor (Gasabsaugung)

Monimet ex
CO2-Sensor/Transmitter Type GMM 04.14.xxx
CO2-Monitor Type GMM 04.14.xxx

  • ex I M1 Ex ia I Ma
  • Linearized measured value display from 0.00...10.00% CO2
  • Version for the gas suction treatment
  • Special housing suited to the working conditions in mines and industry.
  • Adapter with diffusion tube und connection for test gas (optional)
  • Infra-red measurement technique with gas diffusion entry
  • Increased accuracy by compensation of prevailing air-pressure and temperature by microcontroller
  • Illuminated four-digit display
  • Output range of the output signal is variable
  • Adjustments or status enquiries by means of a press button unit or a magnetic pointer. The housing need not be opened
  • Code lock to prevent unauthorized manipulation (can be switched off)
  • Fault self diagnosis with alpha numeric display
  • Test of the output signal by simulated CO2 values
  • Choice between normed analog or digital output signals (optional)
  • Two built-in limit switches with optocouplers or relays in the monitor
  • Housing protection rating IP65, sensor protection rating IP 52

The economical, permanently installed CO2-Sensor/transmitter and CO2-Monitor are characterised by their stable measuring characteristics also in damper and sulfur- or halogen containing atmosphere, simple and secure operation, robustness and compact construction.

These devices conform to the explosion protection rating of intrinsic safety „i“, catagory I M1 Ex ia I Ma. This means that this device can be used in the zone M1 of underground mines, even when unpermitted high concentrations of the methane gas are prevailing.
This certification conforms to the ATEX directive 94/9/EG for devices and protective systems permitted for use in areas endangered by explosions.

The CO2-Monitor differs from the CO2-Sensor/transmitter because of an additional limit value unit which is equipped with optocouplers or relays. The measurement of the carbon dioxide concentration in the sensor block is by means of an selective two channel NDIR-absorption sensor. The gas diffuses into the measuring chamber through a sinter metal disc. To increase the measurement accuracy, a microcontroller continously compensates the prevailing temperature and air-pressure values. A built-in pressure sensor (optional) assures for a high measurement accuracy over a wide pressure range. The gas supply of the suction pipe is achieved by an adapter with diffusion tube. The adapter contains a dust filter and a connection for the test gases.

The operation of the device is very simple: The operator places a small magnetic press button unit on the device. The housing need not be opened. As an alternative he can also use a magnetic pointer. A four digit code which can be entered initially, protects against unauthorized changing of the set values. A self monitoring microcontroller system not only processes the measurement values precisely, it also carries out the operator specific instructions such as the entry of the code, signal instructions and messages, analog and digital outputs and test functions etc. A four digit back lit graphic display shows the measured values in 12 mm high digits.

These devices are protected against shocks, dust and humidity by a cast metal housing (impact strength 20 Joule) and are to be connected by means of a plug-in connector. The sensor block with the CO2-sensor is attached on the lower side of the housing.
The adapter can be used for the mounting of the device. Alternatively a steel hanger or thread holes on its rear side can also be used for the mounting.

PDFDownload Description + Technical Data